Jiggin’ Spoons

Jiggin’ Spoons thumbnail
Mike Iaconelli

I’ve been out in San Diego, California, doing some saltwater fishing for my new TV show. We’ve been using jigging spoons, but in two ways besides just letting them fall to the bottom and then jerking them up or snapping them at a predetermined depth. So, for this blog the term jigging spoon is a little misleading.

Early in the morning when the baitfish are up on top we’ve been casting them out and holding the rod tip real high as we cranked them back with an occasional twitch of the rod tip. They work really well for that kind of fishing.

Later in the day, when the sun was up higher, the baitfish would drop down and so would the fish that were holding under them. When that happened we’d let our spoons drop down to where the baitfish were — one foot per second — and then bring them back the same way except that we’d hold our rod tips lower to help keep our spoons down.

Molix Mike Iaconelli Lover Spoon
Molix Mike Iaconelli Lover Spoon

Finally, in the middle of the afternoon when the sun was high and it was getting hot, we fished them in a more traditional manner, snapping them up off the bottom.

A lot of anglers think only of jigging spoons as jigging lures. But they are much more than that. They’ll do the exact same thing in freshwater for you that they did for us in saltwater. All you have to do is pull them shallow and horizontal early, pull them deeper and horizontal in the late morning and pop them off the bottom in the afternoon.

I’ve done everything I’m describing to you here in Bassmaster Elite Series tournaments. It will work for you just like it has worked for me.

My choice for a jigging spoon is the Molix Mike Iaconelli Lover Spoon. My usual preference is the 3/4-ounce size. It’ll cast a mile. It’s as tough as a 10 penny nail, and it looks like the real thing. But, good as it is right out of the package, I make two modifications to it that make it even better.

The double hook is tucked tight to the body
Molix Mike Iaconelli Lover Spoon

First, I replace the back treble with a feathered one. (I don’t mess with the two prong front hook.) I don’t really know why but this makes it more effective. And, I never tie directly to the lure. I always add a split ring or a snap to the line tie. That gives it just a little more action, especially when it’s moving horizontally.

VMC X-Rap Tail Treble Hook
VMC X-Rap Tail Treble Hook

My Lover spoon comes in 5 colors. The best color is the one that most closely resembles the local forge where you’re fishing. This is a reaction lure but it needs to look natural. Color is a big part of looking natural.

Hobie Mirage Pedal Kayak
Hobie Mirage Pedal Kayak

PS: If you want to have as much fun with a spoon as I had out in California, fish one out of a  Hobie Mirage Pedal Kayak. You’ll be right down at the fish’s level. There’s nothing better than that.

 

 

Watch Mike fish the jigging spoon in San Diego:

Iaconelli in San Diego

Going Ike Episode 1: Kayak Fishing For Yellowtail In San Diego

And here Mike talk about the jigging spoon:

Going Ike - Season three, Episode 1, Recap
Going Ike – Season three, Episode 1, Recap

____________________________________

Subscribe to Mike’s YouTube channel, Going Ike,  to ensure you see every adventure video.

Return to Mike Iaconelli’s website

The Umbrella Rig

The Umbrella Rig thumbnail
Mike Iaconelli

If you’re even half-serious about bass fishing you should learn to fish the umbrella rig. It’s somewhat controversial but in the end it’s a real fish catcher, controversy or not.

However, let me give you a warning before we go any further. Some tournaments allow it, some don’t. And, the number of hooks that you’re allowed to have on one rig or rod varies widely from one state to the next. Make sure you know the rules before you start throwing it.

Another thing: Right now, on Going Ike! I’m fishing one with Britt Myers. Check it out if you want to see some real action.

Shane's Rig
Shane’s Rig

With that out of the way let’s get started.

The umbrella rig is at its best in the early spring and in the late fall. That’s when bass are seriously relating to baitfish, and no lure or rig on the planet mimics a ball of baitfish better than an umbrella rig. It’s a crazy looking thing with its mass of wire and turning blades but it absolutely mesmerizes bass when it’s rigged properly.

Proper rigging means starting with the right harness. My choice is a Shane’s Rig.   (I’m not sponsored by them. Nevertheless, it’s the best one I’ve ever used.) I like the ones that can be rigged with anywhere between five and 10 lures.

VMC Darter Head Jig
VMC Darter Head Jig

My favorite head is a VMC Darter Head, and I don’t worry much about the color. I’m partial to the 1/8-ounce weight but at times I will go up to 1/4 ounce. I rig everything except the one in the center with a small Berkley HAVOC Beat Shad. I always pick one that looks like the local shad — white, gray, smoke, ghost or whatever.

Berkley HAVOC Beat Shad
Berkley HAVOC Beat Shad

On the center head I use a Berkley PowerBait Hollow Body usually in a Hitch color. I use this bigger bait, and in a different color, because I want to create a target for the bass. If they’re moving in on the center lure, they’re more likely to grab an outside lure during an attack, a feeding frenzy or just out of desperation

Berkley Powerbait Hollow Belly
Berkley Powerbait Hollow Belly

Note: My tackle does not include a heavy saltwater rod and reel and I’m not using rope for my fishing line. That is totally unnecessary. Don’t overdo your tackle. Use medium-heavy bass tackle and you’ll do just fine with an umbrella rig.

Abu Garcia Ike Power Series Casting Rods
Abu Garcia Ike Power Series Casting Rods

The only thing you do when you fish an umbrella rig is throw it out and wind it back. Vary your depth in the water column until you find them. I suggest you hang on after that.

Nothing else need be said.
_______________________________

Mike Iaconnelli
Mike Iaconnelli

 

 

 

 

Umbrella Rig Fishing with Britt Myers Recap Bass Fishing Video

 

 

Mike Iaconelli, Gerald Swindle, Adrian Avena
Mike Iaconelli, Gerald Swindle, Adrian Avena

 

Ike, Swindle, Avena Talk about A-rig or Umbrella Rig Bass Fishing Video

 

 

______________________________________________________________________

Like Ike on Facebook,  and follow him on Instagram and Twitter to see weekly Vlog for Going Ike episode, along with fishing and fun content.

Subscribe to Mike’s YouTube channel, Going Ike,  to ensure you see every video.

Return to Mike Iaconelli’s website

 

How to Set and Use Reel Drag

Old rules don’t always apply when using braided line.

By Lenny Rudow

I was outgunned, pure and simple. Jigging for bluefin in the 40- to 80-pound range, I was using 30-pound-class gear with 65-pound braid and a 30-pound fluorocarbon wind-on leader when something significantly larger than expected inhaled my rather puny 4-inch pink Butterfly jig. It would take two and a half hours — and an immense expenditure of sweat — before we finally saw color.

The tuna settled into its death spiral for a final tug of war about 20 feet below the boat. But with the drag set at 10 pounds of pressure, forcing the fish any farther up in the water column was simply impossible. Should I apply a bit more drag, or thumb the spool? These questions shoot through the minds of countless anglers in the final moments of an epic battle.

We all know what forcing the issue usually leads to: a heart-breaking break-off. So instead of tightening the drag, I backed it off and we pulled the boat away from the fish, changing the angle of attack from vertical to nearly horizontal.

The bluefin came out of its spiral and allowed itself to be brought to the surface, albeit 50 yards away from the boat. I kept the pressure steady but never exceeded that of the preset drag, as the boat paralleled the fish, inching closer and closer. Too tired to turn and dive, the fish’s left eyeball was locked on my own when 10 minutes later, the gaff struck home.

The experience proved that ­having your drag properly set — and then using it properly — is quite literally a make‑or-break factor.

A Fine Line
“The old standard of setting the drag to between 25 percent and a third of the line’s rated strength still holds true,” says Shimano rep Capt. Bryan Williams of Wilmington, North Carolina, “but braid has changed things. In the old days, we’d move up the drag on big fish, but now I tell people to leave it alone.”

Williams notes that as a fish takes line, the drag pressure increases without any assistance from the angler because the spool’s diameter shrinks. Move the drag lever forward, and you stand an excellent chance of breaking off. He says the same goes for spinning reels, even though the change isn’t as noticeable. Adding pressure by thumbing the spool on any reel is an even worse move, he says, because you want the line moving as smoothly as possible.

“With today’s smaller, smoother reels, such as the Talicas I fish, touching the spool creates uneven pressure and increases the chance of pulling the hook,” he says.

Williams does point out, however, that you have to vary how you set the drag according to the type of fishing you’re doing. When targeting grouper, for example, he cranks up the drag to the point that only a very large fish can take drag, and then only a little. “You have to force those fish away from the ledges very quickly,” he explains, “or you’ll get chafed off before the line has a chance to break from the fish’s pull.”

Under Pressure
Capt. Will Burbach of Tampa, Florida, who spends much of his time forcing large snook out of mangroves and away from piers and bridges, uses drag pressure the same way. “Fishing in heavy cover, you can’t set your drag for small or average fish,” Burbach says. “You have to use heavier gear and really crank down on the drag. Yes, you will break off sometimes, but if you fish a light drag, you’ll get fouled or cut off almost all the time.”

When fishing in open water, such as targeting tarpon on the beach, Burbach says you can go lighter on the drag without as much break-off risk. Still, he says he sets drags at a third of the line’s breaking strength and often is willing to risk setting it even higher. “Part of it has to do with the fish,” he explains. “It has a better chance of recovery if you don’t stretch out the fight, and wear it down too much.”

Burbach also says that regardless of how you’re fishing, the worst thing an angler can do is fiddle with the drag on a spinning reel midfight. “Sometimes people loosen the drags I’ve set because it feels tight to them, and the next thing you know, they’re tangled in the mangroves,” he says. “Or maybe they overtighten an already tight drag, and break off. If you start messing with settings while a fish is on the line, you’ll never know where the drag is and where it really belongs.”

Setting the Mark
Interestingly, Williams and Burbach differ on how to set the drag in the first place. Williams always uses a scale, with the rod and reel at an appropriate fish-fighting angle. Burbach, on the other hand, says setting by feel works well, just as long as you know your gear inside and out. He tests the drag strength by pulling line by hand directly from the reel. He admits that this technique does require some trial and error, and says you’ve “gotta get the feel” through experience before you’ll be setting drags properly.

Capt. Kevin Beach, who runs Pale Horse out of Venice, Louisiana, uses both methods. “I set my drags by hand with the light stuff, and by scale with the heavy stuff,” he says. Beach also points out that it’s critical to set to your leader strength, not your line strength, when you’re forced to use lighter leaders to get bites from finicky fish.

Okuma’s product development ­director John Bretza stresses the importance of getting to know your gear. “I would take the time to familiarize myself with a new reel before use,” he says. “The drag systems in today’s reels can be your best advantage over big fish, but when used incorrectly, can have the opposite effect. Imagine driving a car and rather than gradually coming to a stop at a light, you slam on the brakes. If you don’t have a good feel for your drag and understand how the system works, and you overtighten the drag, you’ll have the same abrupt impact when a fish strikes your lure or bait.”

Like Williams, Bretza also notes that the rising popularity of braid has had a significant impact on how anglers set and use their drags. The elimination of significant stretch means that anglers using braid have a much less forgiving system. When the drag is set right, however, you have more firepower at your fingertips than anglers have ever had in the past, and being outgunned doesn’t mean you can’t catch that fish of a lifetime.

Drag Tech
By all accounts, the use of carbon fiber is one of the most important advancements in drag technology during the past decade. When compressed, it doesn’t have the same memory found in previously used drag materials. That memory could cause a major issue if an angler failed to loosen a reel’s drag for storage.

Carbon fiber also allows for the application of wet-drag systems, which include greases and can reduce start-up inertia and heat buildup. “We use Cal’s grease on Okuma lever drags,” says John Bretza, Okuma director of product development, “because it has proved to help reduce heat buildup.”

Shimano rep Bryan Williams says that Shimano’s Dartanium II woven carbon-fiber drag materials allow smaller reels to put out a lot more pressure than in the past. “Today I can hand a kid or a small woman a reel like a Trinidad 16, which anyone can handle, but it still puts out a lot of drag,” he says. “They fight the fish instead of fighting the gear.”